Newsletter
Elite
Elite back
Elite logo
Power Redundancy
Stabilization Systems
Telemetry
Jeti USA
Jeti back
jeti logo
Transmitters
Receivers
Telemetry
Axi Motors
axi back
axi logo
V2 Brushless
Sailplane
CycloneAccessories
Axi Motors
secraft back
secraft logo
Tx/Rx Accessories
Securing Systems
Fuel Systems
TopmodelCZ
topmodel back
topmodel back
TD/E-Sailplanes
Scale Sailplanes
E-Hotliners
Opale
opale back
opale logo
Paragliders
Paramotors
Wings & Pilots

SWB Double-Loc Servo Arms 4-40 (Futaba/Red/25T/6mm)


Price: $19.00
Type:
SWB Double-Loc Servo Arms 4-40 (Futaba/Red/25T/6mm)
SWB Double-Loc Servo Arms are designed to clam around and eliminate any inconsistencies in the servo output shafts.

SWB Double-Loc Servo Arms 4-40
Aluminum Servo Half Arm 1" (25mm)
Aluminum Servo Half Arm 1.25" (32mm)
Aluminum Servo Half Arm 1.5" (37mm)
Aluminum Servo Half Arm 2" (50mm)
Aluminum Servo Full Arm 2.5" (61mm)
Aluminum Servo Full Arm 3" (74mm)
Aluminum Servo Full Arm 4.5" (114mm)
Aluminum Servo Offset Arm 3" (74mm)
Aluminum Servo Offset Arm 3.5" (89mm)
Aluminum Servo Offset Arm 4" (98mm)

Halve arms are measured from the servo screw hole to the outside hole.Full arms are measured from the outside hole to the outside hole.

* Click here for Pull-Pull Wire Explanation!!!

Note: SWB's servo arms should fit snug, and not just slip onto the output shaft. In fact they should go on a about a 1/3 of the way with light pressure and use the screw to pull them down the rest of the way. We do this because we are all after the tightest linkage and if there is any play in the spline fit it will only get worse. If need be, place a drop of light oil in the servo arm hole being very careful not to get any oil in the servo screw hole to help get the arm in place. Remember oil in the servo screw hole will not let the Loctite work properly. We suggest the arms will be installed outside the aircraft and on a stable flat surface.
 

Product Reviews:

(0 Ratings, 0 Reviews)